LC-2CP-MD pump can be run totally submerged or can be run in open air for complete moisture protection. The pump can be serviced with the use of a screwdriver. The only moving part other than the motor, is the Impeller Assembly, which rotates on a stationary shaft and up against a thrust washer. This is the only part that can wear out, and may need to be replaced.
OPERATION:
Pumps are not self priming and will not produce a suction lift and must be installed with a positive flooded suction. We rely on the liquid being pumped to lubricate the Impeller Assembly spinning on the stationary shaft. If the pump is run dry for longer than 60 seconds, the plastic may “freeze” onto the shaft.
ELECTRICAL:
Models are standard in 115 Volt, 60 Hz, 1 phase A.C. All cords set are U.L. approved 18/3 wire SJT plastic cords. Standard cord length is 6 feet.
